User's Manual

I210 GPRS SmartMeter User Guide

5 Requirements and Compliance

The I210 GPRS SmartMeter is compliant with all applicable Federal Communications Commission (FCC)

requirements. The FCC identification numbers for the I210 GPRS SmartMeter are listed as follows:

FCC identifier: QHC-I210GPRS

IC Identifier: 4393B-I210GPRS

This certification is granted to SmartSynch Inc.

5.1 FCC Grant Statement

The antennas used for this transmitter must be installed to provide a minimum separation

distance of 20 cm from all persons, and must not be co-located or operate in conjunction

with any other antenna or transmitter.

5.2 Compliance Statement (Part 15.19)

The I210 GPRS SmartMeter complies with Part 15 of the FCC Rules and RSS-210 of the IC. Operation is

subject to the following two conditions:

1. This device may not cause harmful interference, and

2. This device must accept any interference received, including interference that may cause

undesired operation.

5.3 Warning (Part 15.21)

Changes or modifications not expressly approved by GE and SmartSynch Inc. could void the user’s

authority to operate the equipment.

5.4 RF Radiation Safety Guidelines per Part 2 of FCC Rules and

Regulations

The meter should be installed in a location where there will be a separation greater than 20 cm (8 inches)

from locations occupied by humans.

5.5 User Information (Part 15.105)

The I210 GPRS SmartMeter has been tested and found to comply with the limits for a Class B digital

device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection

against harmful interference in a residential installation. This equipment generates, uses and can radiate

radio frequency energy and, if not installed and used in accordance with the instructions, may cause

harmful interference to radio communications. However, there is no guarantee that interference will not

occur in a particular installation. If this equipment does cause harmful interference to radio or television

reception, the user is encouraged to try to correct the interference by one or more of the following

measures:

• Reorient or relocate the receiving antenna.

• Move the receiving equipment farther away from the I210 meter.

• Consult the dealer or an experienced radio/TV technician for help.