User Manual
Table Of Contents
- Contents
- List of Figures
- List of Tables
- List of Procedures
- Before You Begin
- CCU4 Collector Overview
- Installation Considerations
- Installing the CCU4 Collector
- Servicing the CCU4 Collector
- CCU4 Collector Specifications
- Troubleshooting
- Index
DRAFT
Chapter 4 - Servicing the CCU4 Collector 33
Field Replaceable Parts
Reconnecting the Means of Transmitting to the Headend
If you are installing the CDPD modem version (part # CCU-4011-001), you must attach the
CDPD antenna. If you are installing the POTS modem version (part # CCU-4012-001), you must
reconnect the POTS cable.
To Attach the CDPD Antenna to the New Collector
1. Insert the antenna through the hole in the top of the hanging plate and align it with the N-
connector on top of the unit.
2. Press the antenna onto the connector, and turn the antenna clockwise until it no longer
turns and is firmly in place.
To
Reconnect the POTS Cable
1. Press the cable connector onto the communications port and seat it tightly in place.
Installing the Battery Pack in the New Collector
The battery pack ships uninstalled in the same container as the collector. If the collector was
configured at the depot, the battery pack may be stored in the battery compartment for transport.
Caution Do not connect the battery pack to the collector until the collector is in place on
the pole. If you connect the battery pack prior to installation, the collector may record
erroneous data and the battery pack may completely lose power.
To Install the Battery Pack in the New Collector
1. Using a flathead screwdriver, loosen the four captive-screws holding the battery case in
place.
2. Pull out the battery case.
The strap keeps the case connected to the bottom of the
collector
.
3. Connect the battery pack to the connector inside the battery compartment.
4. Place the battery pack inside the battery case and insert the case into the battery
compartment.
5. While pressing the battery case into the battery compartment, finger-tighten the four
captive-screws until the battery case is held in place.
6. Using the flathead screwdriver, tighten the four captive-screws until the battery case is
firmly in place.
Reconnecting the Power Cable
To Reconnect the Power Cable
1. Press the power cable connector onto the 5-pin power connector on the
collector
and seat
it tightly in place.