User Manual

DRAFT
Chapter 4 - Servicing the CCU4 Collector 31
Field Replaceable Parts
12. Lower the collector down and away from the hanging plate, and set it aside.
Figure 14: Collector Shown Detached from Hanging Plate
Attaching the New Collector to the Hanging Plate
To Attach the New Collector to the Hanging Plate
1. With one hand, hold the
collector below the hanging plate and align the L-bracket holes on
the unit with the slots on the hanging plate.
2. Insert each of the four 1/4-20 x 3/4-inch hex-head bolts through a slot and into an L-bracket
hole.
3. Tighten the bolts just enough that the unit hangs from the plate but is still loose enough
that you can slide it up and down in the slots.