User Manual
Table Of Contents
- Contents
- List of Figures
- List of Tables
- List of Procedures
- Before You Begin
- CCU4 Collector Overview
- Installation Considerations
- Installing the CCU4 Collector
- Servicing the CCU4 Collector
- CCU4 Collector Specifications
- Troubleshooting
- Index
DRAFT
Chapter 4 - Servicing the CCU4 Collector 29
Field Replaceable Parts
6. Using the flathead screwdriver, tighten the four captive-screws until the battery case is
firmly in place.
7. Disconnect the power cable from the 5-pin power connector on the
collector
.
8. Turn the RF antenna on the bottom of the collector counter-clockwise, and unscrew it from
the N-connector.
9. Remove the means of communicating with the headend. This depends on which version
of the collector you are removing.
• If you are removing the POTS version (part # CCU-4012-001), disconnect the POTS
cable from the communications port on the collector.
Battery Pack
Battery Case