User Manual
Table Of Contents
- Contents
- List of Figures
- List of Tables
- List of Procedures
- Before You Begin
- CCU4 Collector Overview
- Installation Considerations
- Installing the CCU4 Collector
- Servicing the CCU4 Collector
- CCU4 Collector Specifications
- Troubleshooting
- Index
DRAFT
Chapter 3 - Installing the CCU4 Collector 23
Installation Procedure Summary
Verifying the Collector is Operational
Once the collector is installed and receiving power, it should appear onscreen at the headend. To
verify the collector is receiving power and the software is operating correctly, you must call the
headend and give the administrator the IP address and the number of the collector. If the
administrator identifies the collector onscreen, the installation is complete.
To Verify the Collector is Operational
1. Call the headend.
2. Give the administrator the ID number of the collector and its IP address.
3. Wait for the administrator to identify the collector onscreen.
• If the administrator sees the collector, the installation is complete.
• If the administrator does not see the collector, proceed to the troubleshooting section
of this manual.