User Manual
Table Of Contents
- Contents
- List of Figures
- List of Tables
- List of Procedures
- Before You Begin
- CCU4 Collector Overview
- Installation Considerations
- Installing the CCU4 Collector
- Servicing the CCU4 Collector
- CCU4 Collector Specifications
- Troubleshooting
- Index
DRAFT
22 CCU4 Collector Field Installation and Service Guide
TDC-0359-000b 04/02
Installation Procedure Summary
To Connect the Collector to the Secondary Power Wires
1. At the power line, connect the unterminated end of the cable to the power source on the
pole, as shown below. Consult the following table for definitions of the wires in the AC
power cable.
Figure 12: Connecting the Collector to the Secondary Power Wires
2. Wrap any excess cable around the davit or use tie-wraps (not included) to secure the cable
away from the unit.
3. Connect the other end of the power cable to the 5-pin power connector on the
collector
.
Table 5: AC Power Cable Wire Definitions
Wire Description Pin #
Black Line side 5
White Neutral 1
Power Cable
from CCU4
Shielding for
Power Cable
Drip Loops
120V
Neutral
Cable
Ties