User Manual
Table Of Contents
- Contents
- List of Figures
- List of Tables
- List of Procedures
- Before You Begin
- CCU4 Collector Overview
- Installation Considerations
- Installing the CCU4 Collector
- Servicing the CCU4 Collector
- CCU4 Collector Specifications
- Troubleshooting
- Index
DRAFT
Chapter 3 - Installing the CCU4 Collector 19
Installation Procedure Summary
4. Run the other end of the cable to the communication port on the CCU4 collector. Wrap
any excess cable around the davit or use tie wraps (not included) to secure the cable.
5. Connect the cable to the communications port on the collector.
Figure 9: Connecting the POTS Cable
Installing the Battery Pack
The battery pack ships uninstalled in the same container as the collector. If the collector was
configured at the depot, the battery pack may be stored in the battery compartment for transport.
Caution Do not connect the battery pack to the collector until the collector is in place on
the pole. If you connect the battery pack prior to installation, the collector may record
erroneous data and the battery pack may completely lose power.
To Install the Battery Pack
1. Using a flathead screwdriver, loosen the four captive-screws holding the battery case in
place.
2. Pull out the battery case.
The strap keeps the case connected to the bottom of the
collector
.
3. Connect the battery pack to the connector inside the battery compartment.
4. Place the battery pack inside the battery case and insert the case into the battery
compartment.
To POTS
Communications
Port