User Manual
Table Of Contents
- Contents
- List of Figures
- List of Tables
- List of Procedures
- Before You Begin
- CCU4 Collector Overview
- Installation Considerations
- Installing the CCU4 Collector
- Servicing the CCU4 Collector
- CCU4 Collector Specifications
- Troubleshooting
- Index
DRAFT
18 CCU4 Collector Field Installation and Service Guide
TDC-0359-000b 04/02
Installation Procedure Summary
2. Press the antenna onto the connector, and turn the antenna clockwise until it no longer
turns and is firmly in place.
Figure 8: Attaching the CDPD Antenna
To Connect the POTS Cable
1. Determine the distance from the
collector
to the POTS port.
2. Cut the cable to the appropriate length, leaving enough cable for routing and slack.
3. Hard-wire the unterminated end of the cable to the POTS port. Refer to the table below to
identify each wire.
Table 4: POTS Cable Wire Colors and Signal Names
Wire Color Signal Name
Green Tip
Red Ring
Black Ground
Yellow no connection
CDPD Antenna
RF Antenna