User Manual
Table Of Contents
- Contents
- List of Figures
- List of Tables
- List of Procedures
- Before You Begin
- CCU4 Collector Overview
- Installation Considerations
- Installing the CCU4 Collector
- Servicing the CCU4 Collector
- CCU4 Collector Specifications
- Troubleshooting
- Index
DRAFT
Chapter 3 - Installing the CCU4 Collector 13
Chapter 3
Installing the CCU4 Collector
This installation involves attaching the CCU4 collector to either the davit (the arm holding the
light fixture) of the light pole or to a davit that has been installed on a wood pole. In either case,
a davit must already be available on which to install the collector. Once the collector is installed,
you must supply it with power either from the photoelectric sensor of the street lamp or from the
secondary power wires of the wood pole.
Required Tools
You need the following tools to install the CCU4 collector on a davit:
• 7/16-inch nut driver, wrench, or ratchet-wrench
• Inch-pound torque wrench with 7/16-inch socket
• Flathead screwdriver
• Itron bubble-level to check the plumb of the collector
• AC circuit tester or volt meter (if installing on a light pole)
• Wire stripper and wire cable sleeve (if installing on a wood pole)
Installation Procedure Summary
You must perform the following procedures to install the CCU4 collector on a davit:
1. Install the hanging plate.
2. Attach the collector to the hanging plate.
3. Attach the RF antenna.
4. Connect the means of transmitting to the headend.
5. Install the battery pack.
6. Supply power to the collector.
7. Verify the collector is operational.