User's Guide

Table Of Contents

Field Configuration Tool

Compliance and Operation Information

Page 2 of 5

FCT Field Configuration Guide

Confidentiality Notice

Confidential Information of Itron®, Inc., provided under nondisclosure

obligations. The information contained herein is proprietary and confidential

and is being provided subject to the condition that (i) it be held in confidence

except to the extent required otherwise by law and (ii) it will be used only for

the purposes described herein. Any third party that is given access to this

information shall be similarly bound in writing.

Trademark Notice

Itron is a registered trademark of Itron, Inc.

All other product names and logos in this documentation are used for

identification purposes only and may be trademarks or registered

trademarks of their respective companies.

For more information about Itron or Itron products, go to www.itron.com.

If you have questions or comments about a software or hardware product,

contact Itron Technical Support Services.

Important Safety and Compliance Information

This section provides important information for your safety and product compliance.

FCC USA intentional radiator compliance statement

This device complies with Part 15 of the FCC Rules. Operation is subject to the

following two conditions:

This device may not cause harmful interference, and

This device must accept any interference received, including interference

that may cause undesired operation.

FCC USA un-intentional radiator compliance statement

This equipment has been tested and found to comply with the limits for a Class

B digital device, pursuant to part 15 of the FCC Rules. These limits are designed

to provide reasonable protection against harmful interference in a residential

installation. This equipment generates, uses, and can radiate radio frequency

energy and, if not installed and used in accordance with the instructions, may

cause harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation.