User's Manual

Table Of Contents

DRAFT

24 Repeater Installation Guide

TDC-0613-003b 03/06

Installing Decorative-Mount Repeaters

Overview Decorative-mount repeaters are designed to “blend in” more with their sur-

roundings. These repeaters are typically installed in developments, residential

areas, or other areas where an emphasis is placed on the appearance of the

device.

Installing a

Decorative-Mount

Repeater

Installing a decorative-mount repeater is a relatively simply process. To install

this type of repeater, follow the steps below.

Step Action

1 Remove the existing photo-electric sensor from the decorative

lamppost. Be sure to note the orientation of sensor window (this typi-

cally faces north).

NOTE The existing sensor is no longer needed. The decorative repeater

has a built-in photo-electric sensor.

2 Slide the rubber seal over the base of the repeater, as shown below. The

seal should lay just below the photo-electric sensor window on the

repeater.

3 If necessary, rotate the socket so that the photo-electric sensor window

will be oriented properly (typically facing north) when the repeater is

installed. If a photo-electric sensor was previously installed, the socket

should already be oriented properly.

Photo-electric

sensor window

Rubber seal