User's Manual

DRAFT
Chapter 3 - Eight-Channel Repeater Installation 23
TDC-0613-003b 03/06
Installing Pole-Mount Repeaters
9 To power the repeater when installing it on a pole without a photo-
electric sensor, you must strip the power cable with wire strippers and
connect the individual wires to the 120V and neutral wires on the pole.
To hard-wire power to the repeater, follow the steps below.
a. Connect the unterminated end of the power cable to the power
source on the pole. The power cable is made up of two colored
wires: black and white. Connect these wires per the items below:
* Black (wire color) - Line side (signal name) - 5 (pin number)
* White (wire color) - Neutral (signal name) 1 (pin number)
b. Wrap any excess cable around the davit or use tie-wraps (not
included) to secure the cable away from the repeater.
c. Connect the other end of the power cable to the 5-pin connector on
the front of the repeater.
10 Before mounting the antenna, ensure the antenna gasket is seated
properly.
Attach the antenna. Be sure not to cross-thread the antenna when
installing it on the repeater. Attach the antenna on the bottom of the
repeater, tightening with a wrench until the antenna makes contact.
TIP To test whether the antenna makes contact, try to wiggle the
antenna. If it seems loose, continue tightening.
Step Action