User's Manual

DRAFT
10 Repeater Installation Guide
TDC-0613-003b 03/06
Installing Pole-Mount Repeaters
8 Provide power to the repeater. This can be done by either using a pho-
toelectric sensor or hard-wiring the repeater with power.
To install the photoelectric power adapter, use the steps below.
To hard-wire power to the repeater, skip to step 9.
a. Note the current orientation of the sensor window (usually it faces
north), so that you can restore it to that orientation when you are
done.
b. Remove the photoelectric sensor.
c. Insert the repeater photoelectric power adapter into the socket and
turn to lock it in place.
d. Re-insert the photoelectric sensor into the socket on the top of the
power adapter.
e. Adjust the adapter to face the photosensor window to its original
orientation by pulling up on the adapter housing and swiveling
the housing.
f. Plug the power cord into the 5-pin connector on the repeater.
g. Use tie-wraps as necessary to secure the cable away from the
repeater housing.
Step Action
Photoelectric power adapter
Photoelectric sensor