User's Manual

DRAFT
Chapter 2 - Single-Channel Repeater Installation 9
TDC-0613-003b 03/06
Installing Pole-Mount Repeaters
5 Position the repeater beneath the davit, making sure that:
• The connectors of the repeater face the street lamp.
• The power cable can easily extend between the power connector
at the repeater and the photoelectric sensor.
• The repeater is placed is at least a 3 inches from the light fixture.
This allows the casing of the fixture to open completely, pro-
viding maintenance access when necessary.
• The bottom plate of the mounting kit is straight along the sides of
the repeater lid and is securely attached.
• The groove on the adjustable bracket of the mounting kit aligns
with the davit.
• The repeater hangs straight down.
6 Swing the unsecured end of the top plate of the mounting kit over the
davit and partially bolt it in place. Then torque both bolts to 40-inch
pounds.
IMPORTANT The two hex bolts must be torqued as specified to achieve
the clamping force needed to withstand 100 MPH. wind. If the bolts are
under-torqued, the necessary clamping force may not be obtained. If
the bolts are over-torqued, the brackets may become overstressed and
clamping force may be reduced.
7 Use a voltmeter to verify that the unit has power. If power is not
present, the repeater will not function. Make any corrections necessary
to provide power before continuing with the installation.
Step Action
3''
Connectors
Bottom
plate
Adjustable
bracket
Top plate