Installation Guide

2. Plug the round end of the USB cable connector into the USB-labeled receptacle on the
Mobile Collector radio.
Connecting the GPS Antenna Cable
Attach the GPS antenna cable from the roof antenna to the connector on the Mobile Collector
radio labeled GPS.
Note: When powered on, the LED indicator is lit to indicate that the GPS antenna is
functioning properly. If the LED indicator is not lit, disconnect and reattach the cable to the
GPS antenna connector. If the LED indicator is lit, continue installing your Mobile Collection
system. If the LED indicator remains unlit, contact Itron support.
Removing the Mobile Collection System
At some point, you may need to remove the Mobile Collection system from the vehicle. This
consists of two tasks.
Task Action See...
1 Shut down and remove the Mobile Collection
computer from the vehicle dock.
Removing the Mobile Collection
Computer from the Vehicle Dock on
page 41
2 Disconnect the cables within the vehicle. Leave the Disconnecting the Cables on page 41
Vehicle Preparation and Hardware Installation Guide 3 Mobile Collection Component Installation
16 February 2021 815-0207-00 REV 001 Itron, Inc. Page 40 of 44