Installation Guide

Antenna Mounting Base Installation
The following diagram shows the parts of the integrated antenna base.
ID Component
1 Mounting stud
2 Locating tab
3 Washer
4 Hex nut
Installing the RF Antenna Cable and Mounting Base
1. At your selected location, cut a 0.75 (3/4) inch hole in the mounting surface for the mounting
stud to pass through.
2. Cut a 0.218 (7/32) inch hole that is 0.85 inches from the center of the first hole for the locating
tab.
3. Clean the mounting surface and bottom of the antenna.
4. Feed the cables through the large hole and route to desired locations inside the vehicle:
Mobile Collector mounting location and, if applicable, the GPS receiver location.
5. Apply a bead of silicone sealant around both holes.
6. Position the antenna on the mounting surface, inserting the mounting stud through the large
hole and the locating tab in the small hole.
7. From under the mounting surface (inside the vehicle), slide the washer on the mounting stud
and screw on the hex nut.
Vehicle Preparation and Hardware Installation Guide 2 Vehicle Preparation
16 February 2021 815-0207-00 REV 001 Itron, Inc. Page 13 of 44