User's Manual Part 2

Installing the Mobile Collection 2.x System
To connect the antennas and power cables
1. Plug the power cable (1) into the power connector on the Mobile Collector.
2. Attach the pre-wired RF antenna cable (2) and turn the knurled part of the antenna
cable clockwise until the cable is firmly attached.
If the power cable does not reach the Mobile Collector, use the optional
extension cable to extend the length (extension cables may be purchased
from Itron). Plug the power cable into one end of the extension cable and
plug the other end of the extension cable in to the Mobile Collector. Be sure
both ends snap into their respective connectors.
3. Attach the GPS cable to the connector. Both the end of the cable and the connector are
gold-plated for easy identification.
Attach the GoBook to the Mobile Collector 2.x
This section shows you how to connect both the GoBook MAX and GoBook III to the
Mobile Collector radio. The GoBook may be either attached directly to the Mobile
Collector radio or attached to a vehicle cradle mounted on a pedestal by the driver (for more
information, see
GoBook Mounting Systems on page 32).
To attach the GoBook to the Mobile Collector, follow the steps in one of the following
sections:
GoBook MAX Procedures GoBook III Procedures
Attach the GoBook MAX to the Mobile
Collector
on page 36
Attach the GoBook III to the Mobile
Collector
on page 37
Attach the GoBook MAX to the Vehicle
Dock
on page 38
Attach the GoBook III to the Vehicle
Dock
on page 39
Hardware Installation Guide 35