User's Manual Part 2

Chapter 2 Using the Mobile Collection 2.x System
3. While gently applying downward pressure, rotate the collector back and forth slightly
until the three pins on the base fit into the three matching holes on the underside of the
Mobile Collector.
4. Grip two corners of the Mobile Collector that are opposite each other diagonally and
rotate it counter-clockwise until you hear the locking pin snap into the underside of
the Mobile Collector.
When finished, the rear of the Mobile Collector should be flush with the side of the
base and its rear connectors should face the passenger door.
Connect the Antennas and Power Cables
The RF antenna, GPS antenna, and Mobile Collector power cable should be pre-installed in
the vehicle and routed to where the Mobile Collector will be installed.
The GPS system for version 2.x Mobile Collectors is an optional component that
is part of the Mapping system. If your installation does not include Mapping,
simply attach the RF antenna and the power cable in the procedure below; ignore
the steps related to the GPS antenna.
This section shows you how to connect the antennas and the power cable to the rear of the
Mobile Collector radio.
34 Hardware Installation Guide