User's Manual Part 2

Installing the Mobile Collection 2.x System
The GoBook III mounts onto the Mobile Collector radio within the mounting guides, but
communicates through a USB cable and is powered from a cable connected to the Mobile
Collector.
Vehicle Dock / Pedestal Option
Optionally, you may mount the GoBook on a vehicle cradle that is attached to a pedestal.
This option allows you to position the Mobile Collector in the vehicle so that it is closer to
the driver, while placing the Mobile Collector and its base elsewhere in the vehicle. A key
inserted into the locking mechanism turns clockwise to lock the GoBook MAX in place; a
similar mechanism will be available for use with the GoBook III.
Installing the Mobile Collection 2.x System
This section shows you how to properly install a Mobile Collection 2.x system, with either a
GoBook III or a GoBook MAX.
Attach the Mobile Collector 2.x to the Sled
A plate installed on the underside of the Mobile Collector contains holes and slots that mate
with the pins on top of the sled. Attach the Mobile Collector to the sled by lowering it onto
the pins and rotating it so that the pins slide into the slots, locking the Mobile Collector in
place.
To attach the Mobile Collector to the Sled
1. Hold the Mobile Collector over the base and orient it so that the right rear corner faces
the passenger door.
2. Lower the Mobile Collector onto the sled and gently move it around until the center
pin on the base snaps into the center hole on the underside of the Mobile Collector.
Hardware Installation Guide 33