User's Manual Part 2

Chapter 2 Using the Mobile Collection 2.x System
To remove the Mobile Collector from the sled
1. From the passenger side of the vehicle, reach underneath the top of the base and locate
the locking pin knob.
2. Use one hand to pull the knob down, and use the other hand to push a corner of the
Mobile Collector in a clockwise direction.
3. Continue pulling the knob down and pushing until the pin can no longer snap into the
underside of the Mobile Collector.
4. Grip two corners of the Mobile Collector that are opposite each other diagonally and
rotate it clockwise until you cannot rotate it further.
The right rear corner of the Mobile Collector faces the passenger-side door when the
Mobile Collector cannot be rotated further.
5. Lift the Mobile Collector off the base.
6. Unfasten the seat belt and pretensioner and lift the base off the seat.
46 Hardware Installation Guide