User's Manual Part 2

Chapter 2 Using the Mobile Collection 2.x System
5. Plug the vehicle dock USB cable into the USB port on the Mobile Collector by pulling
the SMA connector sleeve back, plugging the connector in to the Mobile Collector,
and releasing the sleeve. This port uses an SMA connector.
Connect the GoBook III Power Supply and USB Cable
The GoBook III receives power from the Mobile Collector radio itself, through a simple
power cable connection. In versions of the Mobile Collection system that use a GoBook
MAX, the power and data connections are integrated into the top of the Mobile Collector
radio.
For the GoBook III, additional cables must be attached to provide the laptop with power and
a data connection. The USB cable is used to provide data collected by the Mobile Collector
radio to the Mobile Interface application running on the GoBook III.
To connect the GoBook III power supply and USB cable
1. Attach the end of the GoBook III power cable (1) to the blue connector on the back of
the Mobile Collector radio (2); this connector is located beneath the main power
supply.
40 Hardware Installation Guide