User's Manual Part 1

Chapter 1 Using the MC3 System
• GoBook III Push in underneath the locking mechanism (1) and then pull the
handle out (2) as shown.
9. Gently lift the GoBook up and away from the cradle.
Disconnecting the Cables
Disconnect the cables from the MC3 and leave them in the vehicle for the next installation
of the system.
To disconnect the cables
1. Complete the procedure
To remove the GoBook from the vehicle dock on page 25.
2. Unplug the cables from the MC3 radio.
3. Unplug all the cables from the GoBook dock EXCEPT for:
• The USB cable (both XR-1 and GoBookIII docks).
• The power cable that is hard-wired to the dock for GoBookIII installations.
4. Unplug the cables from the sled or pedestal junction box.
5. Release the mounting clips on the MC3 harness and remove the MC3 radio.
6. Unbuckle the seat belt securing the sled to the passenger seat and remove the sled
from the vehicle. Leave the pretenstioner attached to the seat belt.
26 Hardware Installation Guide