User's Manual Part 1

Identification
Mobile Collection Hardware Installation Guide
04/28/2008 TDC-0770-001
Copyright
© 2007 - 2008 Itron, Inc. All rights reserved.
Trademark Notice
Itron is a registered trademark of Itron, Inc.
All other product names and logos in this documentation are used for identification purposes only and may be trademarks or registered trademarks of their respective companies.
Suggestions
If you have comments or suggestions on how we may improve this documentation, send them to [e-mail]
If you have questions or comments about the software or hardware product, contact Itron Technical Support:
Contact
• Internet: www.itron.com
• E-mail: [e-mail]
• Phone: [phone]
Disclaimers
RF EXPOSURE
To comply with FCC requirements, maintain a separation distance of at least 40.0 centimetres between the antenna and all persons.
ELECTROMAGNETIC COMPATIBILITY
Use only approved accessories with this equipment. In general all cables must be high quality, shielded, correctly terminated, and normally restricted to 2 meters in length. The Mobile
Collector Lite employs special provisions to avoid radio interference and should not be altered or substituted.
Unapproved modifications or operation beyond or in conflict with these instructions for use, may void authorization by the authorities to operate the equipment.
WARNING! Do not visually monitor or physically adjust the Mobile Collection system while driving. While driving,
rely on the beeps produced when meter data is collected to indicate proper system operation. Visually monitoring
or adjusting the Mobile Collection system while driving will divert your attention from your safe driving
responsibilities.
Attention to driving is your primary responsibility, along with following all the applicable driving
regulations
.