User's Manual Part 1

Installing the MC3 System
2. Push the button in until the adapter pops out of the slot.
3. Pull the adapter the rest of the way out.
4. Remove the compact flash card from the adapter.
Mounting the MC3
The MC3 is mounted in a harness that can be attached to either a bucket- or bench-seat in a
vehicle. The harness contains clips on the top for mounting it on a bucket seat, and clips on
the side for bench seat mounting. The MC3 is shipped in its vehicle mount, with the straps
set up for a bucket seat. The bench straps are included in the container the MC3 was
shipped in.
Mount the sled before mounting the MC3 on the seat.
If you are using a sled to secure the GoBook, be sure to mount the MC3 high enough on the
seat that the sled and laptop will fit easily beneath it. If you are using a pedestal mount, the
MC3 can be attached lower if desired.
To mount the MC3 on the seat
1. If the MC3 radio has been removed from its harness:
• Slide the radio into its harness, with the MC3 label showing through the
opening on the front of the harness.
Hardware Installation Guide 9