User's Manual
Table Of Contents
- Using the MC3 System
- Using the Mobile Collection 2.x System
- About the Mobile Collection 2.x System
- GoBook Mounting Systems
- Installing the Mobile Collection 2.x System
- Removing the Mobile Collection 2.x System
- Upgrading to a GoBook XR-1 Laptop
- Using the EkaNet System
- System Maintenance
Installing the MC3 System
Hardware Installation Guide 5
To install the seat belt pretensioner
Follow the procedures in the Mobile Collector Sled and Pretensioner Installation
Guide (TDC-0708-xxx). A DVD showing the installation is also included with your
kit. These materials are located in a plastic sleeve on the underside of the sled.
Installing the Junction Box
The junction box takes power from the vehicle and distributes it to the MC3 radio, GoBook,
and an optional EkaNet radio (when installed).
Before you can install the MC3 system for the first time, the junction box must be installed
on either the sled or a pedestal mount.
Once installed, the junction box should remain attached to the sled or pedestal.
To install the junction box
1. Remove the junction box from the MC3 kit.
2. Locate the sled or pedestal mount on which the junction box will be installed. In the
following example, a sled is used.
3. Using a Phillips screwdriver, remove the two screws holding the junction box bracket
in place.