User's Manual
Table Of Contents
- Using the MC3 System
- Using the Mobile Collection 2.x System
- About the Mobile Collection 2.x System
- GoBook Mounting Systems
- Installing the Mobile Collection 2.x System
- Removing the Mobile Collection 2.x System
- Upgrading to a GoBook XR-1 Laptop
- Using the EkaNet System
- System Maintenance
Removing the EkaNet System
Hardware Installation Guide 69
To remove the EkaNet system
1. Ensure that the vehicle is turned off.
2. Ensure that the GoBook has completed processing reads and is properly shut down.
3. Disconnect the following from the EkaNet radio inside the vehicle:
Antenna (connected to the top of the radio and pouch).
Power and serial communications cables (located on the bottom of the radio
and pouch).
4. Remove the radio and pouch from the vehicle. You can either:
Unclip the pouch from the strap it is attached to. Then unbuckle the strap and
store it with with EkaNet radio and pouch.