User's Manual
Table Of Contents
- Using the MC3 System
- Using the Mobile Collection 2.x System
- About the Mobile Collection 2.x System
- GoBook Mounting Systems
- Installing the Mobile Collection 2.x System
- Removing the Mobile Collection 2.x System
- Upgrading to a GoBook XR-1 Laptop
- Using the EkaNet System
- System Maintenance
Installing the EkaNet System
Hardware Installation Guide 67
8. Connect the other end of the power cable to the port on the bottom of the radio. Note
that in the following example, the pouch, vehicle, and other cables have been removed
for emphasis.
9. Connect the serial cable to COM 1 serial port on the laptop (or dock); this is the end
without pins. Be sure to securely connect the cable.
For the GoBook XR-1, the serial port is located on the right-hand side of the
laptop (9-pin male connector).
For the GoBook III, the serial port is located on the back of the laptop (9-pin
male connector).