User's Manual
Table Of Contents
- Using the MC3 System
- Using the Mobile Collection 2.x System
- About the Mobile Collection 2.x System
- GoBook Mounting Systems
- Installing the Mobile Collection 2.x System
- Removing the Mobile Collection 2.x System
- Upgrading to a GoBook XR-1 Laptop
- Using the EkaNet System
- System Maintenance
Chapter 3 Using the EkaNet System
64 Hardware Installation Guide
3. Insert the EkaNet radio (1) into the pouch (2). The antenna connector (3) must face
the top of the pouch.
4. Close the pouch flap over the radio and snap it shut to secure the EkaNet radio.
5. Clip the EkaNet pouch to a harness strap on the back of the seat where the Mobile
Collection system is installed.
If you are using an MC3 system, clip the pouch to one of the straps that secure
the MC3 radio to the seat. This setup is shown in the picture below.
If you are using a Mobile Collection 2.x system, a black fabric strap is included
with the EkaNet pouch. Route and buckle this strap horizontally around the
passenger seat, and then clip the pouch to it.