User's Manual

Upgrading to a GoBook XR-1 Laptop
Hardware Installation Guide 51
To remove the Mobile Collector from the sled
1. From the passenger side of the vehicle, reach underneath the top of the base and locate
the locking pin knob.
2. Use one hand to pull the knob down, and use the other hand to push a corner of the
Mobile Collector in a clockwise direction.
3. Continue pulling the knob down and pushing until the pin can no longer snap into the
underside of the Mobile Collector.
4. Grip two corners of the Mobile Collector that are opposite each other diagonally and
rotate it clockwise until you cannot rotate it further.
The right rear corner of the Mobile Collector faces the passenger-side door when the
Mobile Collector cannot be rotated further.
5. Lift the Mobile Collector off the base.
6. Unfasten the seat belt and pretensioner and lift the base off the seat.
Upgrading to a GoBook XR-1 Laptop
If you are upgrading from a GoBook MAX or GoBook III laptop that was originally
mounted on top of the MC2.5 Radio to a GoBook XR-1 laptop that is mounted on a
pedestal, use the following instructions. The MC2.5 radio remains mounted on the existing
sled.
Note Before you begin, keep in mind that the MC2.5 Radio will remain the same.
The MC2.5 Radio will still be mounted on the sled, and all the cabling will not
change.
The XR-1 laptop upgrade kit contains the following items: