User's Manual
Table Of Contents
- Using the MC3 System
- Using the Mobile Collection 2.x System
- About the Mobile Collection 2.x System
- GoBook Mounting Systems
- Installing the Mobile Collection 2.x System
- Removing the Mobile Collection 2.x System
- Upgrading to a GoBook XR-1 Laptop
- Using the EkaNet System
- System Maintenance
Chapter 2 Using the Mobile Collection 2.x System
48 Hardware Installation Guide
To insert the flash card
1. Hold the flash card as shown to insert it into the Mobile Collector Flash Card Reader.
2. Insert the card in the flash card reader slot and press it in until it is firmly in place and
the eject button pops out.
Remove the Flash Card
Follow these steps to remove the flash card.
Before removing the flash card, shut down the GoBook. Failure to do so could
result in data loss on your flash card.
To remove the flash card
1. Shut down the GoBook.
2. Press the eject button on the flash card reader.
3. Gently pull the flash card out of the flash card reader slot.
Removing the Mobile Collection 2.x System
At some point, you may need to remove the Mobile Collection system from the vehicle.
Perform the following tasks to remove the Mobile Collection system.