User's Manual
Table Of Contents
- Using the MC3 System
- Using the Mobile Collection 2.x System
- About the Mobile Collection 2.x System
- GoBook Mounting Systems
- Installing the Mobile Collection 2.x System
- Removing the Mobile Collection 2.x System
- Upgrading to a GoBook XR-1 Laptop
- Using the EkaNet System
- System Maintenance
Chapter 1 Using the MC3 System
18 Hardware Installation Guide
To connect power to the MC3
1. Plug one end of the cable into the RF UNIT receptacle on the junction box. Pull the
silver tab on the power cable back, insert the connector into the junction box, twist the
connector so the silver tab lines up with the labeling on the junction box, and release
the tab to lock it into place.
2. Plug the other end into the POWER IN receptacle on the MC3.
Connecting the Antenna
Next, connect the omni-mount RF antenna to the radio.
This antenna has either a fixed-base that is permanently attached to the vehicle, or a
magnetic base that can be attached to and removed from the vehicle as necessary.