User's Manual
Table Of Contents
- Using the MC3 System
- Using the Mobile Collection 2.x System
- About the Mobile Collection 2.x System
- GoBook Mounting Systems
- Installing the Mobile Collection 2.x System
- Removing the Mobile Collection 2.x System
- Upgrading to a GoBook XR-1 Laptop
- Using the EkaNet System
- System Maintenance
Installing the MC3 System
Hardware Installation Guide 11
Sled Systems If you will be installing a sled, be sure to mount the MC3 high
enough on the seat back so that the sled and laptop will fit beneath the radio on
the seat.
Pedestal Systems If you will be attaching the GoBook to a dock on a pedestal,
the MC3 radio can be attached lower on the seat. This configuration is shown in
the following examples.
Depending on whether the vehicle has a separate passenger-side bucket seat or a
bench seat, do one of the following:
Bucket Seat Extend the mounting straps from the driver-facing side of the
vehicle mount (1), and then wrap them around the seat back and buckle them to
the opposite side of the vehicle mount (2).
Bench Seat Connect the optional bench-seat straps to the buckles on the
bottom of the vehicle mount.