User's Manual
Table Of Contents
- Using the MC3 System
- Using the Mobile Collection 2.x System
- About the Mobile Collection 2.x System
- GoBook Mounting Systems
- Installing the Mobile Collection 2.x System
- Removing the Mobile Collection 2.x System
- Upgrading to a GoBook XR-1 Laptop
- Using the EkaNet System
- System Maintenance
Chapter 1 Using the MC3 System
10 Hardware Installation Guide
If you are using a sled to secure the GoBook, be sure to mount the MC3 high enough on the
seat that the sled and laptop will fit easily beneath it. If you are using a pedestal mount, the
MC3 can be attached lower if desired.
To mount the MC3 on the seat
1. If the MC3 radio has been removed from its harness:
Slide the radio into its harness, with the MC3 label showing through the
opening on the front of the harness.
Secure it in place by buckling the two diagonal corner straps (1).
2. Strap the mount to either the front or the back of the passenger-side seat back.
Position the unit within the mount so that when it is strapped to the seat back, the
unit's connectors face toward the passenger-side door.