User's Manual
Table Of Contents
- Using the MC3 System
- Using the Mobile Collection 2.x System
- About the Mobile Collection 2.x System
- GoBook Mounting Systems
- Installing the Mobile Collection 2.x System
- Removing the Mobile Collection 2.x System
- Upgrading to a GoBook XR-1 Laptop
- Using the EkaNet System
- System Maintenance
Installing the MC3 System
Hardware Installation Guide 9
3. Slide the adapter into the PCMCIA slot on the GoBook until it clicks into place.
To remove the flash card adapter
1. Open the CD drive / PCMCIA slot compartment on the right-hand side of the
GoBook.
2. Push the button in until the adapter pops out of the slot.
3. Pull the adapter the rest of the way out.
4. Remove the compact flash card from the adapter.
Mounting the MC3
The MC3 is mounted in a harness that can be attached to either a bucket- or bench-seat in a
vehicle. The harness contains clips on the top for mounting it on a bucket seat, and clips on
the side for bench seat mounting. The MC3 is shipped in its vehicle mount, with the straps
set up for a bucket seat. The bench straps are included in the container the MC3 was
shipped in.
Mount the sled before mounting the MC3 on the seat.