User's Manual

Chapter 1 Using the MC3 System
6 Hardware Installation Guide
4. Slide one end of the junction box into position over the bracket that is still attached;
be sure to orient the junction box according to the label on the sled or pedestal. The
junction box has a recessed edge that the bracket fits into.
5. Insert the other bracket (the one you removed) into the junction box, making sure that
both screw holes are visible through the bracket.
6. Insert and tighten both screws to secure the junction box to the sled or pedestal.
About the Dock
The Mobile Collector dock is used to secure the GoBook to either the sled or a pedestal
mount in your vehicle. It has connections for power and communications between the
GoBook and Mobile Collector radio.
When the XR-1 is attached, the dock must be locked to properly secure the laptop. While in
the locked state, the dock's locking mechanism extends out further from the sled than when
in the unlocked position. A green button also appears next to the locking mechanism when
the dock is locked.
To lock or unlock the dock for the XR-1, push the mechanism in, move it toward the keys
on front of the dock, and then slide it back toward its original position; the mechanism
works in a "V" pattern to lock or unlock the dock.
The examples below show the dock on a sled in the unlocked (1) and locked (2) positions,
with an XR-1 attached.