Installation Guide
Table Of Contents
- CCU 100 and Repeater 100 Installation Guide
- Important Safety and Compliance Information
- 1 Before You Begin
- 2 CCU/Repeater Basics
- 3 Planning a CCU/Repeater Installation
- 4 Installing the Collector or Repeater
- 5 Battery Care and Maintenance
- A Detailed Collector or Repeater Specifications
- B Port and Protocol Requirements
- C Status and Diagnostics
- D Changing the Repeater Password
- E Antenna Line Sweeps Procedure
- Anritsu Site Master Calibration
- Testing on a Network Device with a Remotely-Mounted 915 MHz Antenna
- Understanding Party Responsibilities
- Itron ChoiceConnect Antenna and Line Sweep Test Form
- Itron ChoiceConnect 915 MHz Antenna Specifications
- Typical Coaxial Cable Specification Summary Table
- Sample Sweeps Output
- F Grounding Specifications
- Understanding Grounding and Bonding
- Exterior Grounding System Design for Concentrators
- Equipment Buried Ground Ring
- Chemical Ground Rod Installation
- Itron Concentrator Equipment
- Installing Coax Ground Kits
- Collector Sites with Indoor Itron TCU / CCU Equipment
- Grounding Rooftop Network Devices
- Down Conductor Installation
- Cold Water Pipe Option
- Building Steel Option
- Antenna and Coax Grounding - Rooftops
- Grounding antennas on rooftops
- Cable Tray Grounding
- Water Tower Grounding
- New Wooden and Concrete Antenna Poles
- Equipment Shelter Grounding
- Repeaters on Communication Tower Sites
- Repeaters on Rooftops
- Multiple Story Site Ground System
- Down Conductors Installation - Building / Shelter Penetrations
- Down Conductors Installation - Limits of Bend Radius
- Down Conductors Installation Connection Methods
- Cable Entrance Facilities
- Clamp-On Ground Resistance Testing
- Understanding Party Responsibilities
Assembling the Tower CCU 100
Important! This unit must be installed in accordance with the National Electrical
Code and with all local codes. Provide power to the cabinet using electrical conduit.
Itron recommends using a knockout punch and die (such as a Greenlee® Slug-
Buster®) to punch the appropriate sized hole in the bottom of the cabinet.
1. Attach the TCU to the TCU mounting plate.
a. Insert the TCU mounting disc into the mounting plate keyhole.
b. Slide the TCU down until you feel it click into place.
2. Connect the cable from the TCU to the RF filter.
3. Connect the ground wire to the TCU.
4. (Optional) Connect the Ethernet cable to the TCU and the top of the 10/100 BT SPD.
23 June 2020 TDC-0971-012 Itron, Inc. Page 58 of 134
CCU 100 and Repeater 100 Installation Guide 4 Installing the Collector or Repeater