CAT3 Module for the OW CAT-M1 Meter Technical Reference Guide Effective Date: August 2021 CAT3 Communications Module
Revision History The following table describes the changes to this document for each revision of the CAT3 module: Revision A Date Description of Change August, 2021 Initial Release CAT3 Communications Module
Labeling The following requirements will be applied to any products that use these modules: The OW CAT-M1 meter or host label will include the following text for the CAT3 module: Contains: FCC ID: SK9CAT3, IC: 864G-CAT3, Model: CAT3 FCC ID: N7NHL7800M, IC: 2417C-HL78M, Model: HL7800-M The user’s manual for any product that contains this modules will contain the following text. If the device is large enough, then this will also be placed on the label.
ISED RSS-Gen Notice “This device complies with Industry Canada’s licence-exempt RSSs. Operation is subject to the following two conditions: (1) This device may not cause interference; and (2) This device must accept any interference, including interference that may cause undesired operation of the device.” “Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence.
Miscellaneous The user’s manual for any product that contains this module will contain the following text: Professional Installation This module is intended for professional installation by the integrator. The OEM integrator is still responsible for the FCC/ISED compliance requirement of the end product, which integrates this module.
This technical reference guide describes the installation of the CAT3 module for the Itron OW CAT-M1 meter. Installation The CAT3 module will be installed in the Itron OW CAT-M1 electricity meter.
Install the CAT3 module on the host board assembly.
Meter Base (showing metrology) Meter Base with CAT3 module installed CAT3 Communications Module
Meter Base with CAT3 and register boards installed Complete Host Meter CAT3 Communications Module
CAT3 Communications Module
