User Manual

ManualsBrandsItron ManualsElectronicsCentron C1A3B Meter Module

Table Of Contents

5015 B.U. Bowman Drive Buford, GA 30518 USA Voice: 770-831-8048 Fax: 770-831-8598

Certification Exhibit

FCC ID: SK9C1A-3B

IC: 864G-C1A3B

FCC Rule Part: 15.247

IC Radio Standards Specification: RSS-247

ACS Project Number: 15-0533

Manufacturer: Itron Electricity Metering, Inc.

Model: C1A3B

Manual

Summary of content (9 pages)

PAGE 1
Certification Exhibit FCC ID: SK9C1A-3B IC: 864G-C1A3B FCC Rule Part: 15.247 IC Radio Standards Specification: RSS-247 ACS Project Number: 15-0533 Manufacturer: Itron Electricity Metering, Inc. Model: C1A3B Manual 5015 B.U.
PAGE 2
CENTRON C1A3B Meter Module Technical Reference Guide Effective Date: February 2016 C1A3B Meter Module
PAGE 3
Revision History The following table describes the changes to this document for each revision of the C1A3B meter module: Revision A C1A3B Meter Module Date Description of Change February 2016 Initial Release
PAGE 4
Labeling The following requirements will be applied to any products that use this module: The end product or host label will include the following text: • *Contains: • FCC ID: SK9C1A-3B • IC: 864G-C1A3B, Model: C1A3B *NOTE: Since the module ID numbers are visible from outside the end product the word “CONTAINS” may be omitted. The user’s manual for any product that contains this module will contain the following text. If the device is large enough, then this will also be placed on the label.
PAGE 5
accepter n'importe quelle interférence reçue, y compris les interférences pouvant entraîner un fonctionnement indésirable. Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and maximum (or lesser) gain approved for the transmitter by Industry Canada. To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the equivalent isotropically radiated power (e.i.r.p.
PAGE 6
Installation The C1A3B module will be installed in the Itron CENTRON electric meter. Shown are the meter base with metrology board, the board to board connector the C1A3B module and the inner and outer cover.
PAGE 7
Install the C1A3B module on to base by clipping module into base brackets.
PAGE 8
Connect the metrology and C1A3B module using the board to board connector.
PAGE 9
Attached the inner and outer cover to complete the assembly.