User's Manual

Installation
CENTRON Meter Technical Reference Guide 2-5
Figure 2.3 New Module Snap-in
7 Replace the board-to-board connector by aligning the top of the connector
with the notches in the circuit board (see Figure 2.4) and pressing gently at the
bottom of connector to mate the connector to metrology board (see Figure
2.5). Then, gently press the top of the connector to mate it to the register
module (see Figure 2.6). The connector is seated correctly when you hear it
snap into place.
Figure 2.4 Circuit Board Notches
Notches (2)