User's Manual

Operation: CVSO OpenWay Register
CENTRON® OpenWay™ Meter Technical Reference Guide 51
Each SCM message contains tamper information. Below is a chart that indicates the tamper
information available in each SCM:
SCM # Indicator # Group
1 1 Meter Inversion
1 2 Meter Removal
2 1 Demand Reset (Push Button)
2 2 Low Battery or End of Billing Schedule (1 Year from end)
Warning
3 1 Billing Events
3 2 Non-Billing Warnings
 Tamper, Event, and Alarms Indicator Behavior: Two bits are used to log the above
alarm, event, and tamper occurrence Groups.
 All Indicators are "Non-Latching", meaning the R300 board continues to increment for
each and every alarm, event, or tamper occurrence each time they happen.
Event, Alarm, and Tamper Assignments for the CENTRON R300CD/CD3 and CENTRON
Polyphase R300CD/CD3 Meters:
 For all Fatal Errors, the R300 stops transmitting.
 For the Diagnostic Checks and Non-Fatal Errors, transmission can be controlled via
PC-PRO+ Advanced software.
Tamper/Event/Alarm 1 SCM 2 SCMs 3 SCMs
Meter Inversion
(Tamper Circuitry)
SCM 1 -
Indicator 1
SCM 1 -
Indicator 1
SCM 1 -
Indicator 1
Meter Removal
(Tamper Circuitry)
SCM 1 -
Indicator 2
SCM 1 -
Indicator 2
SCM 1 -
Indicator 2
Demand Reset
(Push Button)
N/A
SCM 2 -
Indicator 1
SCM 2 -
Indicator 1
Low Battery N/A
SCM 2 -
Indicator 2
SCM 2 -
Indicator 2
End of Billing Schedule
(1 Year from end)
1
N/A
SCM 2 -
Indicator 2
SCM 2 -
Indicator 2
Clear billing data N/A N/A
SCM 3 -
Indicator 1
Energy Register Edit N/A N/A
SCM 3 -
Indicator 1
Test Mode Entered N/A N/A
SCM 3 -
Indicator 1
TOU Schedule Error N/A N/A
SCM 3 -
Indicator 1
Draft