Certification Exhibit FCC ID: SK9ACT1 IC: 864G-ACT1 FCC Rule Part: 15.247 IC Radio Standards Specification: RSS-247 ACS Project Number: 16-0130 Manufacturer: Itron, Inc. Model: ACT1 Manual 5015 B.U.
ACT1 Meter Module Technical Reference Guide Effective Date: July, 2016 ACT1 Meter Module
Revision History The following table describes the changes to this document for each revision of the ACT1 meter module: Revision A ACT1 Meter Module Date Description of Change July, 2016 Initial Release
Labeling The following requirements will be applied to any products that use this module: The end product or host label will include the following text: • • • Contains: FCC ID: SK9ACT1 IC: 864G-ACT1, Model: ACT1 The user’s manual for any product that contains this module will contain the following text. If the device is large enough, then this will also be placed on the label. “This device complies with Part 15 of the FCC Rules.
Under Innovation, Science and Economic Development Canada regulations, this radio transmitter may only operate using an antenna of a type and maximum (or lesser) gain approved for the transmitter by Innovation, Science and Economic Development Canada. To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than that necessary for successful communication.
Installation The ACT1 module will be installed in the Itron OPENWAY RIVA CENTRON electric meter. Shown are the meter base with metrology board, the board to board connector, the ACT1 module, the display and the inner and outer cover.
Install the display on the ACT1 module by pushing metal pins of display into module connector.
Insert module into upper section of inner cover and connect two wired connectors to module.
Connect metrology and the ACT1 module using the board to board connector.
Install lower inner cover.
Install outer cover.
