Installation Guide
Table Of Contents
- Table of Contents
- 1 Important Safety and Compliance Information
- U.S. and Canadian Patent Numbers
- USA, FCC Part 15 Spectrum Compliance
- Canada, ISED Spectrum Compliance
- RF Exposure (FCC/ISED)
- Australia, ACMA Spectrum Compliance
- Transportation Classification
- Modifications, Repairs, Installation, and Removal
- Lithium Battery Safety
- Equipment Repairs
- Intrinsic Safety
- Electrostatic Ignition Hazard
- Module Cleaning
- Do Not Drop
- 2 About the OpenWay® Riva Remote 500G ERT® Module
- 3 Mounting
- 4 Programming
- 5 Specific Meter Manufacturer Installation
- 6 Diaphragm Meter Installation
- 7 Optional Sealant Application Instructions
- 8 Using Gel-cap Connectors to Complete Wiring Connections
13. Peel the protective plastic away from the adhes-
ive side of the encoder.
Important: You must do the next two steps exactly as described or the remote ERT module will not
work properly.
14. Press the curved side of the encoder firmly against the side of the encoder spacing tool as shown
below, with the adhesive side down. Slide the encoder down along the side of the encoder spacing tool
until it touches the surface of the index (as shown below). Using moderate pressure, hold the encoder
firmly against the index, without moving, for 15 seconds to permanently apply the encoder.
15. Remove the encoder spacing tool and lay the
index on a flat, horizontal surface to reduce strain on
the encoder cable.
16. Program the index reading (with the encoder mounted) into the remote module. Read the remote
module and verify that the reading matches the read programmed into the remote module.
25 July 2019 TDC-1678-005 87
500GERT®Module Installation Guide, RemoteMount Chapter 6 Diaphragm Meter Installation