Installation Guide
Table Of Contents
- Table of Contents
- 1 Important Safety and Compliance Information
- U.S. and Canadian Patent Numbers
- USA, FCC Part 15 Spectrum Compliance
- Canada, ISED Spectrum Compliance
- RF Exposure (FCC/ISED)
- Australia, ACMA Spectrum Compliance
- Transportation Classification
- Modifications, Repairs, Installation, and Removal
- Lithium Battery Safety
- Equipment Repairs
- Intrinsic Safety
- Electrostatic Ignition Hazard
- Module Cleaning
- Do Not Drop
- 2 About the OpenWay® Riva Remote 500G ERT® Module
- 3 Mounting
- 4 Programming
- 5 Specific Meter Manufacturer Installation
- 6 Diaphragm Meter Installation
- 7 Optional Sealant Application Instructions
- 8 Using Gel-cap Connectors to Complete Wiring Connections
4-hole front cover gasket:
Itron part number FAB-0014-
003
2-hole front cover gasket:
Itron part number FAB-0014-
002
1-hole front cover gasket:
Itron part number FAB-0014-
001
The Itron replacement index cover gaskets shown below are thicker than standard gaskets and
have a special slot to accommodate the encoder cable. Gaskets are designed for Schlum-
berger/Sprague model 675 and 1000 commercial diaphragm meters. These gaskets may be
incompatible on meters from other manufacturers; alternate cable relief procedures may be
necessary.
Product Mounting Installation Instructions
For remote ERT module mounting with the diaphragm meter, see Mounting on page17.
Diaphragm Meter Mechanical and Wiring Installation
Instructions
Caution: The remote ERT module encoder must be installed at temperatures
between 40° and 95°F to ensure proper adhesion.
25 July 2019 TDC-1678-005 83
500GERT®Module Installation Guide, RemoteMount Chapter 6 Diaphragm Meter Installation