Installation Guide

1 Top anchor screw positions
2 Bottom anchor position for the module U-shaped mount
Order the correct Sensus Sonix direct mount bracket for your installation requirements from
Sensus North American Gas Customer Service. (Brackets and mounting hardware are ordered
separately).
Sensus Sonix direct mount brackets* and mounting hardware
Sensus part number Description
60025-063-00000 1 1/2" FTP, 45Lt, #3 Spg, 60Lt, #4 Spg
60025-063-01000 2" - 11BS, 2" FTP
60025-063-02000 30Lt, #1A Spg, 1 1/4" NPT, #2 Spg, 20Lt
903376 #8-32 x 3/4" SS Fillister-head screws (2 required)
011-14-286-00 Rubber mounting washer (stabilizes bracket and
remote module assembly)
Installing the remote module on the mounting bracket
1. Place the module mounting bracket over the inlet or outlet pipe fitting on the Sonix meter. (The
default position is over the inlet connection. The inlet connection is the left side connection looking at
the front of the meter.)
2. Remove the four 500G ERT module backplate screws and turn the backplate so the module mount-
ing screw holes are to the top of the module (the arrow on the module label must point up). Secure the
module with the four module backplate screws that were previously removed.
3. Slide the mounting lug (now on the bottom of the module) over the bottom anchor. Insert the two top
module mounting screws and tighten in an alternating pattern.
25 July 2019 TDC-1678-005 79
500GERT®Module Installation Guide, RemoteMount Chapter 5 Specific Meter Manufacturer Installation