Installation Guide
Table Of Contents
- Table of Contents
- 1 Important Safety and Compliance Information
- U.S. and Canadian Patent Numbers
- USA, FCC Part 15 Spectrum Compliance
- Canada, ISED Spectrum Compliance
- RF Exposure (FCC/ISED)
- Australia, ACMA Spectrum Compliance
- Transportation Classification
- Modifications, Repairs, Installation, and Removal
- Lithium Battery Safety
- Equipment Repairs
- Intrinsic Safety
- Electrostatic Ignition Hazard
- Module Cleaning
- Do Not Drop
- 2 About the OpenWay® Riva Remote 500G ERT® Module
- 3 Mounting
- 4 Programming
- 5 Specific Meter Manufacturer Installation
- 6 Diaphragm Meter Installation
- 7 Optional Sealant Application Instructions
- 8 Using Gel-cap Connectors to Complete Wiring Connections
Romet Corrector Programming and Requirements Notes
AdEM programming
Note: Meter setup requires confirmation of communication settings with the AdEM cor-
rector. Communication confirmation requires the RometLink software and the Romet com-
munication cable.
1. Install the RometLink software on your PC.
2. Connect the AdEM corrector communication cable to your computer and the AdEM corrector.
3. Add the AdEM meter to your Phone Book.
3a. Open the RometLink software and log on.
3b. From the Talk to Unit tab, select Check > All.
A dialog box opens asking if you want to add the unit in
the Phone Book.
Click Yes.
3c. Click Close.
3d. Confirm that the meter was added to the Phone
Book.
3e. Set up the corrected or uncorrected parameters.
25 July 2019 TDC-1678-005 76
500GERT®Module Installation Guide, RemoteMount Chapter 5 Specific Meter Manufacturer Installation