Installation Guide
Table Of Contents
- Table of Contents
- 1 Important Safety and Compliance Information
- U.S. and Canadian Patent Numbers
- USA, FCC Part 15 Spectrum Compliance
- Canada, ISED Spectrum Compliance
- RF Exposure (FCC/ISED)
- Australia, ACMA Spectrum Compliance
- Transportation Classification
- Modifications, Repairs, Installation, and Removal
- Lithium Battery Safety
- Equipment Repairs
- Intrinsic Safety
- Electrostatic Ignition Hazard
- Module Cleaning
- Do Not Drop
- 2 About the OpenWay® Riva Remote 500G ERT® Module
- 3 Mounting
- 4 Programming
- 5 Specific Meter Manufacturer Installation
- 6 Diaphragm Meter Installation
- 7 Optional Sealant Application Instructions
- 8 Using Gel-cap Connectors to Complete Wiring Connections
Galvanic Gas Micro Installation
This section describes installation to Galvanic compatible correctors.
Meter model Meter notes Module type Itron part
number
ERT module
notes
GasMicro Elec-
tronic Volume
Corrector
Must select 2
pulses/second
from pulse output
on the output fre-
quency menu.
500G remote ERG-7000-
503
ERT module
cut cable
requires cus-
tomer-supplied
cable capable
of terminating
the module
white and blue
wires at the
meter interface.
Galvanic Installation Overview
Installing the 500G remote ERT module to a Galvanic volume corrector involves four tasks.
1. Programming or verifying that the volume corrector is set up to work with the 500G remote
ERT module. Programming requires a computer communication cable.
2. Connecting the ERT module to the volume corrector. Completing the connections requires a
wire stripper and flat-tip screwdriver sized to tighten the terminal connections on the Gal-
vanic corrector.
3. Mounting the remote ERT module. Select the mounting option appropriate for your install-
ation. See Mounting on page17. Mounting options include:
■
Wall mount on a sheet metal surface
■
Pipe mount using the Itron pipe mount kit CFG-0005-003
4. Programming the 500G remote ERT module. For programming information, see Pro-
gramming on page22. Programming requires an Itron ERT programming device (for
example, an FC300SR).
500G remote ERT module configuration with the meter is dependent on your system application.
See the Galvanic corrector product documentation for configuration information.
Galvanic Product Mounting Instructions
See the Galvanic product documentation for custom mounting instructions.
25 July 2019 TDC-1678-005 41
500GERT®Module Installation Guide, RemoteMount Chapter 5 Specific Meter Manufacturer Installation