Installation Guide
Table Of Contents
- Table of Contents
- 1 Important Safety and Compliance Information
- U.S. and Canadian Patent Numbers
- USA, FCC Part 15 Spectrum Compliance
- Canada, ISED Spectrum Compliance
- RF Exposure (FCC/ISED)
- Australia, ACMA Spectrum Compliance
- Transportation Classification
- Modifications, Repairs, Installation, and Removal
- Lithium Battery Safety
- Equipment Repairs
- Intrinsic Safety
- Electrostatic Ignition Hazard
- Module Cleaning
- Do Not Drop
- 2 About the OpenWay® Riva Remote 500G ERT® Module
- 3 Mounting
- 4 Programming
- 5 Specific Meter Manufacturer Installation
- 6 Diaphragm Meter Installation
- 7 Optional Sealant Application Instructions
- 8 Using Gel-cap Connectors to Complete Wiring Connections
A Connect to Remote window opens.
4. Select the following parameters:
■
Connection Type: Direct
■
Communications Port: enter your computer's port number
■
Baud Rate: enter the baud rate that displayed in Step. 2.
5. Click OK.
6. Click View/Config.
The Field Manager window opens and displays
the settings for the current connection.
7. Click the Setup Parameters tab at the bottom of the parameters window. A parameters window
opens.
8. Enable POut 5 (17, 18) and set the additional
parameters as required in the Uncorrected Pulse
Output Setup at the lower right of the window.
Important: If your software does not have an
option to use POut for the uncorrected pulse out-
put, contact Eagle Research to get the correct
software version.
25 July 2019 TDC-1678-005 33
500GERT®Module Installation Guide, RemoteMount Chapter 5 Specific Meter Manufacturer Installation