Installation Guide
Table Of Contents
- Table of Contents
- 1 Important Safety and Compliance Information
- U.S. and Canadian Patent Numbers
- USA, FCC Part 15 Spectrum Compliance
- Canada, ISED Spectrum Compliance
- RF Exposure (FCC/ISED)
- Australia, ACMA Spectrum Compliance
- Transportation Classification
- Modifications, Repairs, Installation, and Removal
- Lithium Battery Safety
- Equipment Repairs
- Intrinsic Safety
- Electrostatic Ignition Hazard
- Module Cleaning
- Do Not Drop
- 2 About the OpenWay® Riva Remote 500G ERT® Module
- 3 Mounting
- 4 Programming
- 5 Specific Meter Manufacturer Installation
- 6 Diaphragm Meter Installation
- 7 Optional Sealant Application Instructions
- 8 Using Gel-cap Connectors to Complete Wiring Connections
11. Connect the red remote ERT module wire to pin 1 on the K1 terminal port.
12. Twist the remote ERT module's blue and white wires together.
13. Connect the twisted blue and white wires to ter-
minal 2 on the K1 terminal port.
Eagle Research Corrector Programming and Requirements Notes
Important! This information is subject to change without notice. Refer to the Eagle
Research product documentation to verify the most current programming and con-
figuration information for the 500G remote ERT module.
Using Itron 500G remote ERT modules with Eagle Research volume correctors requires Eagle
Research Field Manager software configured with the parameters for your model of Eagle
Research corrector.
Using Eagle Research Field Manager to Change the MPplus Settings
1. Open the Eagle Research Field Manager from
the Start menu or the desktop shortcut.
2. Connect the communications cable from your computer into the MS connector on the side of the
MPplus corrector. After the MS connector is connected, take note of the baud rate displayed on the
front of the corrector.
3. Click Connect on the upper left corner of the
Field Manager window.
25 July 2019 TDC-1678-005 32
500GERT®Module Installation Guide, RemoteMount Chapter 5 Specific Meter Manufacturer Installation