Installation Guide
Table Of Contents
- Table of Contents
- 1 Important Safety and Compliance Information
- U.S. and Canadian Patent Numbers
- USA, FCC Part 15 Spectrum Compliance
- Canada, ISED Spectrum Compliance
- RF Exposure (FCC/ISED)
- Australia, ACMA Spectrum Compliance
- Transportation Classification
- Modifications, Repairs, Installation, and Removal
- Lithium Battery Safety
- Equipment Repairs
- Intrinsic Safety
- Electrostatic Ignition Hazard
- Module Cleaning
- Do Not Drop
- 2 About the OpenWay® Riva Remote 500G ERT® Module
- 3 Mounting
- 4 Programming
- 5 Specific Meter Manufacturer Installation
- 6 Diaphragm Meter Installation
- 7 Optional Sealant Application Instructions
- 8 Using Gel-cap Connectors to Complete Wiring Connections
9. Align the ERT module back-plate mounting holes
with the pipe mount adapter plate holes. Install the two
one-inch ERT module mounting screws from the install-
ation kit. Tighten the module mounting screws evenly
in an alternating pattern. Tighten the screws to 9 to 12
inch-pounds torque.
10. Insert the tamper seals.
11. Gather the excess ERT module cabling into a loop
and use the cable tie to secure the gathered cable to
the pipe.
Adapter Plate Mounting Positions
Note: The notch at the top of the adapter plate (1) must always be at the top position. The fol-
lowing illustrations show the various mounting configurations. The adapter plate mounting
screw locations are indicated (2).
45-degree angle with the
pipe running to the right
45-degree angle with the
pipe running to the left
Horizontal
25 July 2019 TDC-1678-005 20
500GERT®Module Installation Guide, RemoteMount Chapter 3 Mounting the Remote 500G ERT Module