Installation Guide
Table Of Contents
- Cellular 500W Module Remote Installation Guide
- Contents
- New in This Document
- 1 Important Safety and Compliance Information
- 2 About the Itron Cellular 500W Module
- 3 Initializing and Connecting
- 4 Installing the Cellular 500W Remote Module
- 5 Completing Gel-cap Connections Using the Itron Splice Kit
- 6 Using the Itron Cable Armor
- 7 Troubleshooting
Pulser-type Register Connections 18
Connecting Using an Extension Cable 18
Verifying Operation 18
4 Installing the Cellular 500W Remote Module 20
Mounting Accessories 20
Installing the Module Cable Strain Relief 21
Securing the Cable Strain Relief 21
Installing the Backplate 23
Attaching the Backplate 23
Pipe Mount Installation 25
Mounting the Pipe Bracket on a Vertical Pipe 25
OpenWay Riva Leak Sensor (OLS) Installation 28
Connecting the SET Valve 28
Completing the SET Valve Wire Connections 29
Remote Mount Installation 29
Installing on a Flat Surface 29
Direct-mounting to the Meter Register 31
Direct-mounting on the ABB Scancoder, InVision, or Digital Direct-Mount 31
Direct-mounting to a Badger Direct-Mount Register 33
5 Completing Gel-cap Connections Using the Itron Splice Kit 38
Required Materials 38
6 Using the Itron Cable Armor 41
Installing the Itron Cable Armor 41
7 Troubleshooting 43
10 March 2021 815-0618-00 REV 000 Itron, Inc. Page 4 of 43
Cellular 500W Module Remote Installation Guide Table of Contents